Round Drop (2) - Add 1 6mm Crystal Ab Round and a Scallop Bead Cap to an Eye Pin. Approximately 1/8 inch above top crystal a create loop using loop directions. Repeat 1time. Lt Sapphire Teardrop Drop (10) - Add 1 Lt Sapphire 11x7mm crystal teardrop to a headpin. Approximately 1/8 inch above top crystal create a loop using loop directions. Repeat 9 times.
1. Take one 5mm jump ring and open it. Add it to the eye of the eye pin on the round drop. Close the jump ring. Add 4 more jump rings to create a dangling chain. Your earring should look like this:2. Open one 5mm jump ring, add a Lt Sapphire Teardrop Drop and add it to the top jump ring on your dangle chain. Close the jump ring.3. Open one 5mm jump ring, add a Lt Sapphire Teardrop Drop and add it to the top jump (the same ring you added the last drop to). Make sure this drop is on the other side of the jump ring that is hanging below it. Close the jump ring. It should look like this:4. Open one 5mm jump ring, add a Lt Sapphire Teardrop Drop and add it to the jump ring below the one you added the first teardrop drops to. Close the jump ring.5. Open one 5mm jump ring, add a Lt Sapphire Teardrop Drop and add it to the top jump (the same ring you added the last drop to). Make sure this drop is on the other side of the jump ring that is hanging below it. Close the jump ring. It should look like this:6. Open the bottom jump ring of the dangle chain, add the last Sapphire Teardrop Drop, and close the jump ring. Your earring should now look like this:7. Open the loop of one of the dangle earrings (just twist it like you would a jump ring). add the top loop of the round drop and close the loop of the earring. Your earring is now complete and should look like this:8. All you need to do now is repeat Step 2 for your other earring!! |
