1. String 1 Silver-Plated Bottom Clamp Bead Tip on the Buddy Braids.
2. Make a tight double knot approximately 1 inch from the end on the open side of the
bead clamp. See illustration 1.
3. Squeeze the bottom clamp closed with the knot inside. Trim the excess cord.
4. String the following: 1 SP(Silver-Plated) Disc Metal bead, 1 Black Crystal Bicone bead,
1 Crystal AB Crystal Cube, 1 Black Crystal Bicone bead, 1 Sp Disc Metal bead, 1 Aqua
Crystal Round bead, 1 SP Rondelle with Clear Crystals, 1 Aqua Crstyal Round bead, 1
SP Disc Metal bead, 1 Black Crystal Bicone bead, 1 Crystal AB Crystal Cube, 1 Black
Crystal Bicone bead, 1 Sp Disc Metal bead, 1 Aqua Crystal Round bead, 1 SP Rondelle
with Clear Crystals, 1 Aqua Crstyal Round bead, 1 SP Disc Metal bead, 1 Black Crystal
Bicone bead, 1 Crystal AB Crystal Cube, 1 Black Crystal Bicone bead, 1 Sp Disc Metal
bead, 1 Aqua Crystal Round bead, 1 SP Rondelle with Clear Crystals, 1 Aqua Crstyal
Round bead, 1 SP Disc Metal bead, 1 Black Crystal Bicone bead, 1 Crystal AB Crystal
Cube, 1 Black Crystal Bicone bead, and 1 Sp Disc Metal bead.
5. Thread the other Bottom Tip Bead Clamp with the open end facing away from the last
bead. See Illustration 2
6. Tie a tight double knot as close to the inside of the bottom clamp as you can to
eliminate seeing the Buddy Braids.
7. Squeeze the bottom clamp closed with the knot inside. Trim the excess cord.
8. Insert the loop of one of the bottom clamp bead tips into the 8mm jump ring. Close
the loop.
9. Twist open the 5mm jump ring, add the self-closing clasp, and close the jump ring.
10. Insert the loop of the remaining bottom clamp bead tip into the 5mm jump ring (with
the clasp). Close the loop.
You’re done!!! This pattern makes a bracelet that is approximately 7 inches long. If you would like a larger bracelet just extend pattern.
